HHR Performance » FTECU

FTEcu Kawasaki Active Tune AFR Self Tuning ECU Kit. This Kit lets your FTECU equipped bike tune itself as you ride! Once installed and activated, the ActiveTune kit monitors the fuel mixture making fast and consistent changes to mitigate changing fuel requirements.

This breakthrough system replaces your inadequate stock O2 sensor with a proprietary FTECU lambda controller and the latest generation Bosch LSU 4.9 sensor.

This kit requires:

• Data-Link ECU Flashing Kit ( bike harness required for tuning / data acquisition )
• Exhaust with a standard 18×1.5 O2 sensor bung (optionally cylinder specific bungs)
• Smog block-offs or disabled AIS valve (Graves Smog Block Off plates listed separately) 

This kit includes:

• 1 FTECU YAM-01 Lambda Controller
• 1 Bosch LSU4.9 wideband O2 sensor
• 1 Product Activation Card

Model Fitment:

• Kawasaki ZX10 2016-2019 Note: You will need an 18x1.5mm Lamda Collar in your ZX10 exhaust for this installation this does not come on the stock exhausts but standard on Graves Cat Eliminator and Full Exhaust Systems.
• Kawasaki H2 2015+ Note:  You will need an 18x1.5mm Lamda Collar in your exhaust for this installation 
• Kawasaki ZX-6R 2019 Note:  You will need an 18x1.5mm Lamda Collar in your exhaust for this installation 

Flash Tune Data-Link (Bike side) ECU Flashing Kits for the 2019 Kawasaki ZX-6R + 2017-2019 Z900 : Your bike already has a standalone ECU and now you can get the tools to program it! There is no longer any need to send away your ECU! Note: Bike side kit attaches to the bike to allow lap top access with the included tuning cable.

Fitment:

• Kawasaki ZX-6R 2019 + Z900 2017-2019

This Interface allows you to easily adjust the following!

• Remove ECU Restrictions
• High Load Fuel Maps (with PC3 and PC5 map importing)
• Low Load (cruising) Fuel Maps and Bias Mapping
• Cylinder Specific Ignition Timing by Gear
• Throttle by Wire Adjustments
• Engine Braking Adjustments
• Cooling Fan Temp Adjustment
• Disable Injector Decel cut-off
• and new features are added regularly.
• See screen shot for list of current features

Data-Link ECU Flashing Bike Side Kit Includes:

• FTdataLink ECU Interface USB Cable
• Bike-side programming harness to permanently install on your bike
• FT ECU License to allow unlimited flashes for a single ecu

We believe everyone deserves the same tuning technology that until now was reserved for factory riders. With the FTEcu software you can remove the restrictions that the factory must put in place to meet strict street vehicle guidelines. By flashing your ECU you are able to tune your bike without interfering with critical correction factors resulting in smoother power gains than ever before possible.This product is for RACE USE ONLY! The included software will automatically update as new features are added!

The 2016-2019 Kawasaki ZX10 Flash Tune Data-Link ECU Bike Side Flashing Kit : Your bike already has a standalone ECU and now you can get the tools to program it! There is no longer any need to send away your ECU! Note: Bike side and the separate listing bench tuning kit do the same thing but one tunes off the bike (remove ecu bring to computer) and the other attaches to the bike (this listing attached a small harness to your motorcycle). Scroll down for in-depth kit information. Thank you.

Fitment:

• Kawasaki ZX10 2016-2019

This Interface allows you to easily adjust the following!

• Remove Throttle-By-Wire Restrictions
• Engine Braking adjustments
• High Load Fuel Maps (with PC3 and PC5 map importing)
• Low Load (cruising) Fuel Maps
• Ignition Timing
• Immobilizer Function
• Cooling Fan Temps
• Rev-Limiter Control
• and new features are added regularly.

Bike Side Data-Link ECU Flashing Kit Includes:

• FTdataLink ECU Interface USB Cable
• Bike-side programming harness to permanently install on your bike
• FT ECU License to allow unlimited flashes for a single ecu

We believe everyone deserves the same tuning technology that until now was reserved for factory riders. With the FTEcu software you can remove the restrictions that the factory must put in place to meet strict street vehicle guidelines. By flashing your ECU you are able to tune your bike without interfering with critical correction factors resulting in smoother power gains than ever before possible.This product is for RACE USE ONLY! The included software will automatically update as new features are added!

The Kawasaki ZX636r 2013-2017 Flash Tune Data-Link ECU Flashing Kits : Your bike already has a standalone ECU and now you can get the tools to program it! There is no longer any need to send away your ECU! Note: Bench kit and the seperate listing bike side kit do the same thing but one tunes off the bike and the other attaches to the bike. Scroll down for indepth kit information.

Fitment:

• Kawasaki ZX636r 2013-2017

This Interface allows you to easily adjust the following!

• Remove ECU Restrictions
• Engine Braking adjustments
• High Load Fuel Maps (with PC3 and PC5 map importing)
• Low Load (cruising) Fuel Maps
• Fuel Injector Proportioning
• Ignition Timing
• Immobilizer Function
• Cooling Fan Temps
• Rev-Limiter Control
• Remove Top Speed Limiter
• ECU Based Quick-shifting
• Speedometer calibrations
• and new features are added regularly.

Bench ECU Flashing Kit Includes:

• FTdataLink ECU Interface USB Cable
• Bench Flashing Harness to flash your ECU outside of the bike
• Power Supply for Bench flashing

We believe everyone deserves the same tuning technology that until now was reserved for factory riders. With our software you can remove the restrictions that the factory must put in place to meet strict street vehicle guidelines. By flashing your ECU you are able to tune your bike without interfering with critical correction factors resulting in smoother power gains than ever before possible.This product is for RACE USE ONLY! The included software will automatically update as new features are added!

Flash Tune Data-Link (Bike side) ECU Flashing Kits for the Kawasaki ZX636r 2013-2016 : Your bike already has a standalone ECU and now you can get the tools to program it! There is no longer any need to send away your ECU! Note: Bike side and the separate listing bench tuning kit do the same thing but one tunes off the bike and the other attaches to the bike. Scroll down for indepth kit information.

Fitment:

• Kawasaki ZX636r 2013-2016

This Interface allows you to easily adjust the following!

• Remove ECU Restrictions
• Engine Braking adjustments
• High Load Fuel Maps (with PC3 and PC5 map importing)
• Low Load (cruising) Fuel Maps
• Fuel Injector Proportioning
• Ignition Timing
• Immobilizer Function
• Cooling Fan Temps
• Rev-Limiter Control
• Remove Top Speed Limiter
• ECU Based Quick-shifting
• Speedometer calibrations
• and new features are added regularly.

Data-Link ECU Flashing Kit Includes:

• FTdataLink ECU Interface USB Cable
• Bike-side programming harness to permanently install on your bike

We believe everyone deserves the same tuning technology that until now was reserved for factory riders. With our software you can remove the restrictions that the factory must put in place to meet strict street vehicle guidelines. By flashing your ECU you are able to tune your bike without interfering with critical correction factors resulting in smoother power gains than ever before possible.This product is for RACE USE ONLY! The included software will automatically update as new features are added!

Flash Tune Data-Link (Bike side) ECU Flashing Kits for the all new Kawasaki ZX6 / 636 2005-2008 : Your bike already has a standalone ECU and now you can get the tools to program it! There is no longer any need to send away your ECU! Note: Bike side and the separate listing bench tuning kit do the same thing but one tunes off the bike and the other attaches to the bike. Scroll down for in-depth kit information.

Fitment:

• Kawasaki ZX6 / 636 2005-2008

This Interface allows you to easily adjust the following!

• Remove ECU Restrictions
• Engine Braking adjustments
• High Load Fuel Maps (with PC3 and PC5 map importing)
• Low Load (cruising) Fuel Maps
• Fuel Injector Proportioning
• Ignition Timing
• Immobilizer Function
• Cooling Fan Temps
• Rev-Limiter Control
• Remove Top Speed Limiter
• ECU Based Quick-shifting
• Speedometer calibrations
• and new features are added regularly.

Data-Link ECU Flashing Kit Includes:

• FTdataLink ECU Interface USB Cable
• Bike-side programming harness to permanently install on your bike

We believe everyone deserves the same tuning technology that until now was reserved for factory riders. With our software you can remove the restrictions that the factory must put in place to meet strict street vehicle guidelines. By flashing your ECU you are able to tune your bike without interfering with critical correction factors resulting in smoother power gains than ever before possible.This product is for RACE USE ONLY! The included software will automatically update as new features are added!


This Interface allows you to easily adjust the following!

• Remove ECU Restrictions
• Engine Braking adjustments
• High Load Fuel Maps (with PC3 and PC5 map importing)
• Low Load (cruising) Fuel Maps
• Fuel Injector Proportioning
• Ignition Timing
• Immobilizer Function
• Cooling Fan Temps
• Rev-Limiter Control
• Remove Top Speed Limiter
• ECU Based Quick-shifting
• Speedometer calibrations
• and new features are added regularly.

Data-Link ECU Flashing Kit Includes:

• FTdataLink ECU Interface USB Cable
• Bike-side programming harness to permanently install on your bike

Bench ECU Flashing Kit Includes:

• FTdataLink ECU Interface USB Cable
• Bench Flashing Harness to flash your ECU outside of the bike
• Power Supply for Bench flashing

We believe everyone deserves the same tuning technology that until now was reserved for factory riders. With our software you can remove the restrictions that the factory must put in place to meet strict street vehicle guidelines. By flashing your ECU you are able to tune your bike without interfering with critical correction factors resulting in smoother power gains than ever before possible.This product is for RACE USE ONLY! The included software will automatically update as new features are added!