Rapidbike QUICK SHIFTER KIT ( UP-SHIFT ONLY )

RAPID BIKE QUICK SHIFTER KIT ( UP-SHIFT ONLY )

-To be purchased as a separate accessory for installation with Rapid Bike EVO and Rapid Bike RACING modules.

-Up Shift Assist for all Models

-Can be programmed Push or Pull

-Includes shift Rod

IMPORTANT NOTE: FOR THE INITIAL SET UP OF THE QUICK SHIFTER KIT, IT IS REQUIRED TO BE CONNECTED TO RAPID BIKE SOFTWARE VIA RAPID BIKE USB CABLE ( SAME CABLE THAT CAME WITH YOUR RB EVO OR RACING KIT ) . IF THE INITIAL SET UP IS NOT PERFORMED CORRECTLY, THE SHIFTER WILL NO FUNCTION CORRECTLY.

ELECTRONIC QUICK SHIFTER KIT

K27-SW-GEAR : Strain Gauge/Loadcell quick-shifter kit. This kit is NOT a stand alone system and it must be added to your existing Rapid Bike EVO or Racing fuel management system. It connects directly to the Rapid Bike wiring harness . The load cell can be programmed for push OR pull. Generic shift rod is usually included with the kit but not always since not all bikes require a rod. In the event of rod being included in the kit will be a generic size and it is owners responsibility to perform correct measurements and cut it and secure it properly. We include a rod based on factory rearsets.