Aim MXG 1.2 Motorcycle Dash Data Logger

The 7” MXG 1.2 Motorcycle Dash Data Logger acquires data from your engine ECU, internal accelerometer, internal Gyro and GPS08 Module. Perfect for wider view.   

A Wide Range of Data Sources

Performance and data acquired can also be incremented adding up to eight expansion modules. The only difference between the two is the MXS is a compact 5? display and Aim MXG 1.2 is a 7? display, a better fit for wide cockpit installations.

CAN Output

With the CAN Output you can send messages directly to an existing CAN network in order to improve the range of vehicle control possibilities.

Freely Configurable Pages

You can define all the custom pages you wish, choosing among a wide library of page styles, defining which data to be shown, their end of scale and measure units. Swapping between pages can be managed pushing one or two push buttons.

High Contrast 7? TFT display

The MXG 1.2 Motorcycle Dash Data logger features a high contrast 7? TFT display, fully configurable by a dedicated software. An ambient light sensor keeps the back light at optimum brightness levels.

Flexible Alarms

MXG 1.2 features eight configurable RGB alarm LEDs: you choose the conditions, you choose the colours.  Select a solid alarm or flashing one - and the flashing frequency, choose to have an accompanying text message, and set the alarm priorities.

Two Digital Outputs

Aim MXG 1.2 Motorcycle Dash Data logger features two digital outputs. Each of them can give an output of 1 amp at 12 volts: they can be configured in order to be turned on/off depending on the value of the analogue or digital inputs. They permit to automatically run external systems, i.e. to switch on/off additional lights, to activate/deactivate a cooling fan or circulation pumps, etc. when a certain event happens.

Integrated Shift Light Array

Choose from a host of advanced multicoloured RGB shift light patterns that can be customised to your liking, and for each unique gear when required. 

Expand the system, according to your needs

Using the built-in CAN bus, you can add expansion modules to the MXG 1.2 to increment the performance and the data acquired:


GPS08 Module

Thanks to GPS08 Module (included in the kit) and its Race Studio 3 software, you can immediately get laptimes and all data needed for engine tuning as well as for improving driving technique.

Channel Expansion

It permits to add 4 0-5Volt analogue channels for pressure, temperature sensors and potentiometers. Two of these channels can be configured to receive digital inputs like wheel speed.

TC Hub

It adds 4 K thermocouples.

LCU-One CAN

Wide band Lambda controller LCU-One, with Bosch LSU 4.9 probe, providing all Air/Fuel data and lambda value, allows to perfectly tune the carburetion.

SmartyCam HD cameras

The on-board cameras that overlays on videos the data sampled by your logger.

Connection Example